Tek Screws


Stainless Steel Tek Screws for Antenna Tower Contractors

Stainless Steel Tek Screws, for antenna tower contractors, as the name implies are made of stainless steel and have a hex washer head that makes it convenient to load in a cordless or wired drill. Antenna tower contractors like to use Stainless Steel Tek Screws on their antenna tower work compared to zinc tek screws or black steel tek screws. Stainless Steel Tek Screws resist corrosion which can cause loosening of your fasteners and unsightly rust stains. Our Stainless Steel Tek Screws are a self drilling and self tapping screw, allowing contractors to fasten clips or hardware at any location on their antenna tower work. Stainless steel tek screws have cut point tips that allow for metal penetration without excessive pressure on your tool, naturally metal penetration is dictated by thickness of metal or other fastening materials. Antenna tower contractors find this one of the most convenient pieces of hardware on site.

Stainless Steel Tek Screws come in two sizes. Antenna tower contractors can choose either Part # ST1058 which is a # 10 x 5/8 inch Stainless Steel Tek Screw and is sold in quantities of 500 or Part # ST1114 which is a # 10 x 1-1/4 inch Stainless Steel Tek Screw and is sold in quantities of 100. Stainless Steel Tek Screws provide a wide range of fastening possibilities for antenna tower contractors.

GO TO - FULL HARDWARE SECTION FOR ANTENNA TOWER CONTRACTORS

 

GO TO - FULL LINE OF CELL TOWER WIRELESS PARTS & EQUIPMENT

 

GO TO - SITE PRO 1 HOME FOR ANTENNA TOWER CONTRACTORS

---