Wedge Anchor

Stainless Steel Wedge Anchors for Cell Tower Builders

Stainless Steel Wedge Anchors allows cell tower builders to fasten components or hardware into concrete or other solid masonry type material. Stainless Steel Wedge Anchors are installed by cell tower builders by simply drilling the appropriate size hole and inserting the Stainless Steel Wedge Anchors. Stainless Steel Wedge Anchors are flared at the bottom of the non threaded side and have an attached clip. When you torque the accompanying nut this clip slides and expands on the flared section. cell tower builders should use care in determining the appropriate torque. The expansion flares out within the drilled hole creating a solid fastening system, the more stress applied when torqing the nut the holding power is increased.

Stainless Steel Wedge Anchor Sizes

Stainless Steel Wedge Anchors comes in the following sizes;

Size: 3/8 inch x 2-3/4 inch, Part number: SWA382
Size: 3/8 inch x 3-3/4 inch, Part number: SWA383
Size: 1/2 inch x 3-3/4 inch, Part number: SWA123
Size: 5/8 inch x 5 inch, Part number: SWA585
Size: 3/4 inch x 7 inch, Part number: SWA347

Stainless Steel Wedge Anchors Type 304 for Cell Tower Builders

Stainless Steel Wedge Anchors, also called 304 Stainless Steel Wedge Anchors are made of Stainless Steel for lasting durability against rust and corrosion. Type 304 is the most common and widely used Stainless Steel out of all the Stainless Steel types. Type 304 composition provides the best results for cell tower builders at a fairly low cost. Cell tower builders find them easy to use and a convenient piece of hardware to have in their toolbox or truck.

 

Compare Wedge Anchors

Site Pro 1 - Full Line of Cell Tower Builders Wireless Parts & Equipment

---